CUSTOMER CONCERN: The gap between the freezer drawer and refrigerator door(s) is not even. See figure 1.
Drawer Bolts
Figure 1
Figure 2
CORRECTION PROCEDURE 1. Check that the unit is level.Adjust if necessary. 2. Check that the RC door(s) are aligned. Adjust if necessary. 3. If the gap is still uneven, tighten the four freezer drawer bolts and four freezer basket screws and recheck. See figures 2 and 3.
Four Basket Screws
Figure 3
ALL POINTERS ONLINE: http://www.servicematters.com/tech_ref/tech_ref_main.htm To receive pointers by email, or to edit or delete a current email address, FAX changes to 269-923-5805.
4. If the gap is still uneven, remove the four freezer basket screws, the basket, and the freezer drawer to access the drawer rails. See figure 4.
Eight Rail Screws
Figure 4 5. If the rail screws are tight, and the gap is still uneven after replacing the freezer drawer and basket, order metal shim part number W10123657, to be installed under the rail on the side of the drawer that needs to be raised. A maximum of two shims can be added if necessary. See figure 5.
1.5mm Metal Shim Figure 5 6. To install shim(s), remove the four screws securing the rail to the cabinet. See figure 6. Slide the shim under the rail; reinstall and tighten the screws. 7. Replace the freezer basket and freezer drawer. Check that the drawer gasket is sealing completely and verify that the basket is activating the freezer light switch.
Four Rail Screws
Figure 6
PARA APLICACION INMEDIATA EN SU DEPARTAMENTO DE SERVICIO PRODUCTOS DE LAVANDERÍA
Productos DE REFRIGERACIÓN
ProductOs DE COCINA R4317440 Diciembre 2008
ESTE BOLETIN DE SERVICIO SE APLICA A LAS SIGUIENTES MARCAS
Refrigeradores empotrados con congelador en la parte inferior de Jenn-Air y KitchenAid Modelos:
QUEJA DEL CLIENTE: El espacio entre el cajón del congelador y la(s) puerta(s) del refrigerador no está parejo. Vea la figura 1.
Pernos del cajón
Figura 1
Figura 2
PROCEDIMIENTO DE CORRECCIÓN: 1. Revise que la unidad esté nivelada. Ajústela si es necesario. 2. Revise que la(s) puerta(s) del compartimiento del refrigerador estén alineadas. Ajústelas si es necesario. 3. Si el espacio sigue siendo desigual, apriete los cuatro pernos del cajón del congelador y los cuatro tornillos de la canasta del mismo, luego vuelva a revisar. Vea las figuras 2 y 3.
Cuatro tornillos de la canasta
Figura 3 TODOS LOS BOLETINES EN LÍNEA: http://www.servicematters.com/tech_ref/tech_ref_main.htm Para recibir boletines por correo electrónico, o para corregir o eliminar una dirección de correo electrónico actual, envíe los cambios por FAX al 269-923-5805.
4. Si el espacio aún está desigual, quite los cuatro tornillos de la canasta del congelador, saque la canasta y el cajón del congelador para tener acceso a los rieles del mismo. Vea la figura 4.
Ocho tornillos del riel
Figura 4 5. Si los tornillos del riel están apretados y el espacio sigue siendo desigual aun después de volver a colocar el cajón y la canasta del congelador, pida la calza Pieza número W10123657, para instalarse debajo del riel, en el lado del cajón que necesita elevarse. Se pueden agregar dos calzas como máximo si es necesario. Vea la figura 5..
1,5 mm Calza metálica Figura 5 6. Para instalar la(s) calza(s), quite los cuatro tornillos que aseguran el riel a la carcasa. Vea la figura 6. Deslice la calza debajo del riel; vuelva a instalar y apriete 7. Vuelva a colocar la canasta y el cajón del congelador. Revise que la junta del cajón haga un sellado completo y verifique que la canasta esté activando el interruptor de la luz del congelador.
7. Quite la puerta del refrigerador. 8. Retire la cubierta de la bisagra. Vea la figura 5. 9. Saque los 4 tornillos de la bisagra. Vea la figura 6. 10. Quite la bisagra.
Shut the water off at the water valve after about one quart (1 liter) of water has been flushed through the tubing. FLUSH OUT THE TUBING. 8. SmartConnect™.
to ice cubes. Interior of refrigerator. •See Care and cleaning. needs cleaning. Slow ice cube freezing. Door left open. •Check to see if package is holding door ...
6. Hook the tabs on the left side of the hinge cover (1) under the edge of the top hinge (7) and position the cover in place. Insert and tighten the cover screw (1).
Filter Bypass Plug. You must use the filter bypass plug when a replacement filter cartridge is not available. The icemaker will not operate without the filter or filter ...
pre-cut black or white decorator panels from GE Parts and Accessories, 800.626.2002, or you can add wood panels ...... Saddle valves are illegal and use is not.
alineación del perno prisionero para puerta y la ranura del soporte. Corrección: Procedimiento alternativo para la instalación de la puerta: 1. Instale el tornillo de ...
Light and Cooling Fan will continue to run after each cycle until the oven door is opened. Although, these components continue to run, no Microwave energy is.
Design change to lower freezer basket blocks view of door stud to bracket slot alignment. Correction: Alternate door installation procedure: 1. Install the top right ...
In the space below, record the date of purchase, model and serial number of your product. You will find ...... Never use thin crystal glass or crockery to collect ice.
To turn the cooling system off, tap the WARMER pad for either the refrigerator .... Pull the drawer out to the stop position. Lift the lid to .... back, make sure you don't roll over the power cord or icemaker ... refrigerator, do not rest the front
phone support from a Sears representative on all products. Think of us as a “talking owner's manual.” Power surge protection. • against electrical damage due.
*Aspa del ventilador. Juego de servicio, pieza N° W10181323 contiene un motor, soporte, aspa y hoja de instrucciones. Siga las instrucciones provistas con el ...
Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn-Air, U.S.A., or Maytag ... Cause: Center burner may be miss-wired causing reduced heating.
Marcas afectadas. TODOS LOS BOLETINES EN LÍNEA: https://www.servicematters.com/. Para recibir boletines por correo electrónico o para cambiar o borrar.
Models: See attached. If all components associated with the failure have been checked and found to be good. order new ADC con- trol and replace. Correction: ...
This may cause water or slush to remain in the ice mold during next fill. This results in a double fill and overfilling of the mold. Correction: Order and install a kit ...
Verifique que el revestimiento de la puerta tenga el borde derecho, es decir, que el revestimiento no presente una comba de un ancho superior a una moneda ...
or delete a current email address, go to https://www.servicebench.com/. KitchenAid, Maytag and Whirlpool. 36"Wide Frenchdoor Bottom Mount Refrigerators.
our service center or qualified LG technician to avoid ..... the refrigerator for installing, cleaning or service be sure ...... Department of Public Health ..... arbitration provision is governed by the Federal Arbitration Act. Judgment may be enter
Marque déposée de Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn-Air, U.S.A., Maytag Properties, LLC ou ses sociétés affiliées. ®MAGIC CHEF est une marque ...
For more information on your refrigerator's operation, visit www.GEAppliances.com or .... refrigeration product, check with the company handling the ... Initially, set the refrigerator control at 5 and the freezer control at 5. Allow 24 hours for.