Installation Filter Replacement Instructions GXRTDR

Use the in-line water filtering system on a potable, safe-to-drink, home COLD water ... All of the refrigerator installation requirements must be met when installing ...
756KB Größe 231 Downloads 104 vistas
Installation Instructions

Filter Replacement GXRTDR

Your new GE icemaker water filter comes complete with all the necessary hardware for installation. Each filter gives you up to six months of great-tasting water. Filter should be changed after 6 months of use. REQUIRED TOOLS FOR INSTALLATION

OPTIONAL TOOLS FOR INSTALLATION

• a tube cutter • a knife • a bucket or pan

• a file • sandpaper System is Tested and Certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor and Particulate Class V.

Do not use where water is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

WARNING

Small parts remaining after the installation could be a choke hazard. Discard safely.

The GXRTDR has been tested and Certified by WQA according to CSA B483.1.

SPECIFICATIONS • This System has been tested according to NSF/ANSI 42 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42. • Actual performance may vary with local water conditions. Model GXRTDR

Service Flow rate

Service Life

Pressure

Max. Temp.

0.5 gpm (1.9 lpm)

2500 gal. (9463 liters) or 6 months

25–125 psi (172–862 kPa)

100°F (38°C)

Tested % Reduction Influent Challenge Contaminant % Reduction Required Concn. Required

Average Influent

Average Effluent

Chlorine

70%

≥50%

2.0 mg/L ± 10%

2.0 mg/L 0.59 mg/L

Particulate, Class V particles 30 to