30” Wide Range Models. 3严 Min. .... Drill 1/8严 pilot holes at a 20° angle. □ Secure the ...... Percez des trous repère de 31 mm (1/8严) à un angle de 20°.
wrap pipe thread tape with Teflon* around, all male. (external) pipe threads. ..... wire. Remove 4 burner attachment screws,. 2 at the front and 2 at the back. Slide.
The finished backsplash must cover the entire back wall up to the bottom of a hood, ..... Make sure the flow of combustion and ventilation air to the range is ...
trim forward, then lift up to remove. □ Find the two rear leg extension rods. Use a 1/4严 driver or wrench to adjust the left or right rear legs. □ Replace the rear ...
switch power off at service panel and lock the service disconnecting means to ..... C. Install male 1/2严 or 3/4严 flare union adapter to the. NPT internal thread of ...
rangetop has been design.certified by CSA International according to ANSI Z21.1, ..... at all burners but gas flows from only the one selected. Once air is purged ...
allow anyone to climb, sit, stand or hang on the oven. • Make sure the cabinets and wall coverings around the oven can withstand the temperatures (up to.
A Charcoal Filter Accessory Kit is required for the non-vented exhaust. (See your Owner's. Manual for the kit number.) Adaptor in Place for. Outside Top Exhaust.
Product failure due to improper installation is not ... done by qualified person(s) in accordance with all ... these vent hoods and to reduce the risk of personal.
oven loads of up to 50 pounds or a total weight of up to 160 pounds. CAUTION .... must be shut off while line connections are being made. • Use copper wiring ...
Conecte el Suministro de Agua. 43. Paso 10. Conecte la Corriente. 43. Paso 11. Inicie la Máquina de Hielo. 43. Paso 12. Instale el Zócalo. 43. 31-49142 Rev. 2 ...
Skill Level â Installation of this unit requires basic mechanical .... con 4 personas para una correcta instalación del modelo de 42â o 48â. PRECAUCIÃN.
2x4 or 2x2 lumber for installing runners or 3/8" plywood for floor (if required). • Wood screws or other hardware for installing runner or shelf to support oven (if ...
IMPORTANT NOTE: Maximum weight for door panel is 67 pounds. (30 kg). Maximum .... plastic may crack or rupture with age and cause water damage to your ...
long enough to extend to the front of the refrigerator. Installation of an easily ...... excédentaire ne gêne pas la fermeture du tiroir ou l'installation du coup-de-pied.
Use a 1/16” bit to drill to pilot holes through the metal clearance holes and into the wood soffit. The holes should be centered in the soffit or a 3/4” min. wood.
CONTENTS. Design Information. Models Available ...............................................2. Product Dimensions and Clearances ................4. Tools and Parts Required .
heated or signs of flickering orange due to particles in the gas or air. (A) Soft blue flames ..... box end wrench to loosen and remove and replace the broil orifice.
Note to Installer â Be sure to leave these instructions with the consumer. ⢠Note to Consumer â Keep these instructions for future reference. ⢠Proper installation is ...
runner or shelf to support oven (if required) ..... lift this oven. • Open the door and remove any packaging in oven. .... now ready to be installed. Return to the.
using a 1/16” bit. See Figure 5. 5. Secure the drawer with the 4 screws supplied. Mounting. Flange. Parts supplied. 4 Screws. Permanent and Correct Installation.
switch power off at service panel and lock the service ..... Lock up and away from the front frame. Remove ..... approximately 3 min., the screen area should begin.
