e(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across.
EN Product Safety Information Intended Use: These Air Drills are designed for tapping operations.
WARNING ● Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious injury. ● Always turn off the air supply, bleed the air pressure and disconnect the air supply hose when not in use, before installing, removing or adjusting any accessory on this tool, or before performing any maintenance on this tool or any accessory. ● The Reverse Valve Cap and Actuating Valve Cap are under Spring pressure. Use care when removing either Cap. For additional information refer to Product Safety Information Manual Form 04580353. Manuals can be downloaded from ingersollrandproducts.com
48h. 11. 48h. PMAX. 7. 0. 24h. N u. 9. 8h. (Dwg. 47132600). 1 2 3. 10. IR # - NPT .... circular arrow and defined as h=hours, d=days, and m=months of actual use.
Air Fuse upstream of hose and use an anti-whip device across any hose coupling ... When the life of the tool has expired, it is recommended that the tool be ...
Intended Use: These Air Drills are designed for drilling, honing, reaming and hole sawing. For additional information refer to Product Safety Information Manual ...
i OOO. ---. ---. I valori relativi a suoni e vibrazioni sono stati misurati in conformità agli standard di test riconosciuti a livello internazionale. L'esposizione all'utente ...
*K. 3.5. 4.2. 83.0. 4.5. 42 . 82.0. 4.5. Product Safety Information. Intended Use: These die grinders are designed for grinding, porting, polishing, de-burring, and ...
calificación de aire más alta en la herramienta. Superar .... Si la información se contradice, siga las directrices más restrictivas. ...... Blei von bleihaltigen Farben,.
Page 3 .... électrique est accru si votre corps est en contact avec le sol ou une source de terre. . Ces outils électriques sont uniquement destinés à une utilisation ...
dles or a tool steel that is retained and driven by the Scaler. ... Always turn off the air supply, bleed the air pressure and disconnect the air supply hose when not ...
For additional information refer to Product Safety Information Manual Form .... Ces perceuses pneumatiques sont conçues pour les opérations de perçage, ...
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an ...
slijpsteen of elk ander hulpstuk grondig worden gecontroleerd. ... moet de regelhendel worden losgelaten en de kleine slijpsteen, slijpschijf of elk ander hulpstuk.
It is your responsibility to make this safety information available to others that will ... use an anti-whip device across any hose coupling without internal shut-off, to.
1 ago. 2006 - For additional information refer to Air Pulse Tools Product Safety ... from valve(s) at low point(s) of piping, air filter and compressor tank daily.
Air under pressure can cause severe injury. Never direct air at yourself or anyone else. Always turn off the air supply, bleed the air pressure and disconnect the ...
1 ago. 2006 - ... should only be carried out by an authorized Service Center. Refer all communications to the nearest Ingersoll Rand Office or Distributor.
Tools are coated inside and out with rust-resisting oil before leaving the factory. .... Tool repair and maintenance should only be carried out by an authorized ...
Dry the tool immediately after cleaning, pour 3 cm of Ingersoll Rand. No. 10 Oil into the air inlet and again operate the tool for 5 seconds to lubricate all working ...
Therefore, on site measurements should be used to determine the hazard level in that specific application. Installation and Lubrication. Size air supply line to ...
Course du. Piston. Niveau sonore dB (A). (ISO15744) .... Saisissez la partie de devant par la main et insérez une tige qui passera à travers la valve et entrera en ...
These Riveting Hammers are designed for light weight riveting applications. ...... Opmerking: Voordat u het gereedschap opbergt of het meer dan 24 uur niet ...
