Top left hand slide. T-449FL-0219. 14-11/16â. (372.9 mm). 21-5/8â. (549.5 mm). 12400 Earl Jones Way. Louisville, KY 40299 rev-a-shelf.com. Customer Service: ...
pre-drill pilot holes using. 7/64” bit (See Fig. 2). Adjust the mounting brackets to line up with the holes and attach to the door using (4). #6 x 1/2” flat head screws.
4) Once tray is fitted inside cabinet, use silicon adhesive around the entire perimeter and any holes you made for plumbing. Take care to seal all the cuts to ...
hinges to begin to mount your door. Measure Opening Height ______. Measure Door Height ______. Height Difference ______. Divide Difference by 2 ______.
Note 1: Be sure to measure cabinet opening and basket width to make sure basket ... but note some taller items could hit the shelf when opening and closing.
Mark screw locations to the center of the thick portion of the door at least 12-1/2” from the bottom, pre-drill pilot holes, and attach wood frame to the door with the ...
Don't worry if it is off a little. This can all be adjusted. Double stick tape will hold the door in place while you screw the brackets to cabinet door (See. Figure 7).
Figure C). Finally attach the optional handle and insert the waste container. Note: Handle should only be used if you are not using the optional Rev-a-shelf door.
assemble the trays to the cabinet door using #8 x 5/8” truss head. 7) Once the door is attached, loosen the clamp screw on the white plastic housing (approx.
36” shelf - inside cabinet width must be between 34” to 34-3/16” (864-868 mm). STEP 1. For side mounting: Mark and drill pilot holes for the base brackets to the.
From the hinge side of the cabinet use measurement (B) to align center line. 4) Use an awl or ... 1) Remove (2) screws from side of unit (See Fig B). 2) Install RV- ...
Finally, replace the frame onto the slides then place your waste containers in the wire frame and the installation is complete. STEP 2. With the frame in a closed.
