Modular Conference Table .... Table de conférence modulaire ... Placer toutes les pièces contrecollées sur une surface propre et lisse, comme de la moquette ou ...
Install the 10W LED Bulb (D) into the socket of the lamp holder and screw it tightly in. 6. ... Plug into wall outlet. 8. Turn the lamp on .... Numéro de téléphone. 4.
Mesh Task Arm Chair. Fauteuil de travail en toile. Şilla de Trabajo con Descansabrazos y Malla. LLR69518. Please unscrew all hardware from cushion before ...
If you are missing parts or have other concerns, please email [email protected] or fax: 404-472-9063. ... pièces ou que vous éprouvez d'autres inquiétudes.
Do not tighten all screws/bolts until pieces are completely assembled. • Keep all ... Lay out the parts on a non-abrasive surface such as carpet or blanket.
unclenching your hand. 3. Adjustable seat depth. Press the second button under the right side of seat to adjust appropriate depth a. Four positions slide depth b. Seat depth is adjustable when the button up. First, press the button up and adjust the
Faites flisser la serrure sur la barre entailée (le côté plat doit être aligné sur le bord de la porte extérieure (FIG. J). Il n'est pas nécessaire d'utiliser la clé.
bottom of the post. Repeat this step until you have 4 tall posts assembled. 2. Snap shelf supports onto posts by placing two plastic shelf support halves around ...
NOTE: Please tighten all arm screws using Allen key before Step 5. NOTE : Veuillez serrer toutes les vis des accoudoirs à l'aide de la clé Allen avant l'étape 5.
Dessous de Siège en Verre. Estera de Vidrio para Sillas. 82833/82834/82835. User Instructions. Directives/Instrucciones de Uso. Please read and save the ...
posts into the four holes located at each corner of the shelf. ... les trous de poteaux, dans les tablettes, localisés dans chacun des coins de la tablette jusqu'à ce ...
Replacement panels are not available. lf any damage has occurred during ... out the parts on a non-abrasive surface such as carpetor blanket. Instructions.
Do not tighten all screws/bolts until pieces are completely assembled. • Keep all .... Lay out the parts on a non-abrasive surface such as carpet or blanket.
Do not tighten all screws/bolts until pieces are completely assembled. • Keep all ..... Lay out the parts on a non-abrasive surface such as carpet or blanket.
Draw a line for top and bottom perimeter. Measure down 20mm from the top line of board, and fix two hangers by anchor and screw. 20mm. Measure up 40mm ...
Assembly instructions 81919/81946; 81928/81929. LLR81914 A B C D is E F G H J. LLR81915 Sis. Double Top Desk S. S. se se Aluminum Supports SiwerMetal ...
Model Number LLR68948/LLR68952. Assembly Instructions. Carefully unpack all parts and identify them with parts list before attempting to assemble the chair.
It is recommended for 2 people to complete this assembly. .... If you are missing parts or have other concerns, please email [email protected] or fax: 404-472-9063. ... Note: Our policy is to send all parts requests normal ground transportation, ...
