Sony Alpha A3000 Built-in flash Replacement

Sony Alpha A3000 Built-in flash Replacement Removal of the built-in flash device.

Escrito por: Leonard Holloman

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 1 de 5

Sony Alpha A3000 Built-in flash Replacement

INTRODUCCIÓN This guide shows how to remove the build-in flash of the camera from its compartment. You will need a soldering tool to detach the cables connecting the flash to the camera.

HERRAMIENTAS: Phillips #000 Screwdriver (1) Soldering Station (1)

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 2 de 5

Sony Alpha A3000 Built-in flash Replacement

Paso 1 — Rear Case



Remove the seven highlighted screws shown here.

 Screws are teeny tiny, don't lose them! Paso 2



Remove this final screw from the memory card compartment.



Remove the chassis by pulling the back cover away from the camera.

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 3 de 5

Sony Alpha A3000 Built-in flash Replacement

Paso 3



Gently but forcefully lift up on the parallel cable connecting the two halves of the camera.

Paso 4 — Built-in flash 

© iFixit — CC BY-NC-SA

es.iFixit.com

Remove the single screw from the bottom of the flash device.

Página 4 de 5

Sony Alpha A3000 Built-in flash Replacement

Paso 5 

Remove the flash cover by gently pulling it in an outward direction.



Use a soldering tool to remove the three wires connecting the flash to the camera.

Paso 6

To reassemble your device, follow these instructions in reverse order. La versión más reciente de este documento fue generada en 2017-09-19 03:57:06 AM .

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 5 de 5