Gently open the back case by prying along the edge of the cover, starting at a corner of the phone and circling around the phone using a plastic opening tool.
INTRODUCCIÓN Use this guide to replace the battery in the Nexus 4's battery or to disconnect the battery before accessing the internal components. This short repair will only take a few minutes.
Remove the two screws from the bottom of the phone with a T5 Torx Screwdriver.
Página 3 de 5
Nexus 4 Battery Replacement
Paso 3
Gently open the back case by prying along the edge of the cover, starting at a corner of the phone and circling around the phone using a plastic opening tool.
The opening process may take a few minutes. The plastic will make a light snapping noise as the back cover separates from the rest of the phone.
Paso 4 — Battery
Remove the two 1.8 mm Phillips screws holding down the battery connector.
Using a plastic opening tool, disconnect the battery cable from its socket on the motherboard.
Remove the blue tape that secures the white antenna cable to the battery.
Using a spudger, carefully disconnect the white antenna cable.
Carefully pry the battery out with a Plastic Opening Tool, starting at the top left-hand corner and working down towards the bottom right-hand corner.
If necessary, you can also use a plastic card to separate the battery from the metal midframe. The battery is securely glued to the phone. When reinstalling the battery, press the battery firmly against the adhesive strip.
To reassemble your device, follow these instructions in reverse order. Start by seating the top of the back to the phone, then gently snap the back in place working from the top to the bottom. La versión más reciente de este documento fue generada en 2017-12-29 05:50:16 AM .
Step-by-step navigation to dissemble the phone until battery is accessible, Followed by instructions on how to remove the battery. Escrito por: Zoie E. Motorola ...
To reassemble your device, follow these instructions in reverse order. Este documento foi gerado pela última vez em 2017-09-06 02:27:16 AM. Passo 1 — ...
Tightly pinch the top of the front and back halves of the housing.. Carefully pry the two halves of the housing apart.. BlackBerry 7100g Battery Terminal ...
Carefully insert a Spudger into one of the corners of the tablet.. Slide the Spudger along the edge popping the tabs out along the way.. Be careful not to break the tabs.. Paso 2 — Remove the battery. Slide the Spudger under the battery to lift it of
your Chromebook, so be sure to either wear an anti-static wrist strap or work on a surface ... doesn't generate static electricity, like wood, tile, or other hard floors.
29 sept. 2016 - Escrito por: Dakoda Sanders. INTRODUCCIÓN. If your SoundLink III exhibits significantly decreased battery life or no longer takes a charge, ...
27 oct. 2017 - This guide will show the reader how to remove the battery of their Jazz HDV178 in the case that they will replace the battery or continue on to ...
La versión más reciente de este documento fue generada en 2018-01-06 07:03:25 AM . Paso 1 — Battery. Place your thumb on the right side of the camera over ...
Do this beside the volume button and the micro SD cover. ... The best method to complete this is to pull the bundled cable connector out with your hands. Pull.
Place thumb on top of the triangle and press into the phone while sliding your thumb ... La versión más reciente de este documento fue generada en 2017-09-12 ...
21 oct. 2016 - Audiovox CDM-8910 Battery Replacement. This guide will inform the reader how to access and replace/install the battery for the Audiovox.
Push the release tabs toward the center of the device.. Remove the battery.. Paso 2 — Insert Replacement Battery. Take the replacement battery and insert it ...
Paso 3. Carefully separate the back piece from the device using a plastic opening tool.. Remember to open along the entire perimeter of the tablet.. Paso 4.
Turn the computer over to see the small tab on the battery located near ... Once the tab is in the unlocked position (far right), pull the battery outwards away from ...
Esta guía detalla cómo retirar la placa base de su Nexus 4. HERRAMIENTAS: Phillips # 00 Destornillador (1). iFixit herramientas de la abertura (1). Spudger (1).
Plastic Cards (1). iFixit Opening ... The battery is black and will will ... Using a plastic card or opening pick, separate the battery from the rest of the device.
Over time the battery will begin to not hold a charge as long as it use to or even at all. If you need to constantly have your laptop plugged in or it will not turn on, then the battery might need to be replaced. This guide will help you do just that
