Audiovox CDM-8900 Camera Replacement

Unscrew all five (5) screws on the back of cell phone.. If screws do not remove after fully unthreading, gently invert and tap phone in hand until the.
861KB Größe 0 Downloads 0 vistas
Audiovox CDM-8900 Camera Replacement

Audiovox CDM-8900 Camera Replacement Escrito por: Aaron Shaw

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 1 de 6

Audiovox CDM-8900 Camera Replacement

INTRODUCCIÓN Here is how you remove the camera from the logic board of the cell phone.

HERRAMIENTAS: Phillips #00 Screwdriver (1) iFixit Opening Tools (1)

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 2 de 6

Audiovox CDM-8900 Camera Replacement

Paso 1 — Battery



Hold the phone in one hand, slide latch, and pull to remove the battery.

Paso 2 — Antenna



Grasp antenna at its base and unscrew.

 Remove the antenna along with its plastic casing from inside the battery housing. Keep the antenna in the plastic casing for reassembly.

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 3 de 6

Audiovox CDM-8900 Camera Replacement

Paso 3 — Logic Board



Remove small rubber insert from top of phone to access the top screw.

 Warning: Screws are very small and may be difficult to see while unscrewing. 

Unscrew all five (5) screws on the back of cell phone.



If screws do not remove after fully unthreading, gently invert and tap phone in hand until the screws come loose.

Paso 4



Wedge back plate away from cell phone using the leverage from the plastic spudger.

 The volume control button on the left side of the phone will be loose. Make sure to carefully reinsert during reassembly. 

Detach logic board from LCD screen connector by gently detaching the small copper plate on the top right of the logic board. (shown circled in blue and detached)

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 4 de 6

Audiovox CDM-8900 Camera Replacement

Paso 5



Pop the logic board out from the front of the cell phone.



Before reassembly, be sure keypad is lined up with logic board.



Before reassembly, be sure camera lens is properly aligned at the top of the logic board and volume controls are in place.

Paso 6 — Camera 

Grasp camera.



Slide camera out of slot from logic board.

 Camera is difficult to reassemble; there is a white clip for easy camera replacement. Verify that you orient the camera correctly when reinserting.

To reassemble your device, follow these instructions in reverse order. La versión más reciente de este documento fue generada en 2019-03-26 02:52:11 PM .

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 5 de 6

Audiovox CDM-8900 Camera Replacement

© iFixit — CC BY-NC-SA

es.iFixit.com

Página 6 de 6